Inventor® Training
Master Inventor!
Face Fillets with Autodesk Inventor - Page 3
So anything that would normally get in the way of making the fillet is absorbed by the fillet, but what are the limits of this capability?
The feature will not be absorbed if any full surface of the feature does not touch the fillet. In the image above the radius is set to .299 and the top surface of the cylinder does not contact the fillet. In the image below the radius is set to .300, which causes the top surface to contact the fillet.
Since all the surfaces on the cylinder contact the fillet, it is absorbed.
The Face Fillet command can fillet across gaps as well, but…
Algebra the Game
Teaches Algebra while you Play!
Play on any device connected to the internet.
New!
Algebra the Course - Fundamentals
Prerequisites: None, anyone can learn.
No Installation Required
Watch from any device connected to the internet.
$19.95
Algebra the Course - Fundamentals
This course makes algebra simple. It's based on skills used in Algebra the Game, and it shows you how to solve real life problems.